Entire Combination Meter does not Operate: Procedure

1. Disconnect the E55 connector.
   Fig 1: Identifying Combination Meter Wire Harness Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   E55-30 (ET) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   E55-32 (B) - Body ground	Always	11 to 14 V
   E55-33 (IG+) - Body ground	Ignition switch ON	11 to 14 V

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   2