DTC B1635/24: Rear Airbag Sensor LH Circuit Malfunction: Procedure

1. Turn the ignition switch off.
   Fig 1: Identifying Rear Airbag Sensor LH

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
3. Interchange the rear airbag sensor RH with the rear airbag sensor LH and connect the connectors to them.
4. Connect the cable to the negative (-) battery terminal.
5. Turn the ignition switch on (IG), and wait for at least 60 seconds.
6. Clear the DTCs stored in the memory. Refer to DTC CHECK / CLEAR .
7. Turn the ignition switch off.
8. Turn the ignition switch on (IG), and wait for at least 60 seconds.
9. Check for DTCs. Refer to DTC CHECK / CLEAR .

   Result

   Result	Proceed to
   DTCs B1630/23 and B1635/24 are not output.	A
   DTC B1635/24 is output.	B
   DTC B1630/23 is output.	C

   HINT: 

   Codes other than DTCs B1630/23 and B1635/24 may be output at this time, but they are not related to this check.

B → See step   4 

C → See step   3 

A → See step   2