DTC B1630/23: Rear Airbag Sensor RH Circuit Malfunction: Procedure

1. Turn the ignition switch off.
   Fig 1: Identifying Rear Airbag Sensor RH

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
3. Interchange the rear airbag sensor LH with the rear airbag sensor RH and connect the connectors to them.
4. Connect the cable to the negative (-) battery terminal.
5. Turn the ignition switch on (IG), and wait for at least 60 seconds.
6. Clear the DTCs stored in the memory. Refer to DTC CHECK / CLEAR .
7. Turn the ignition switch off.
8. Turn the ignition switch on (IG), and wait for at least 60 seconds.
9. Check for DTCs. Refer to DTC CHECK / CLEAR .

   Result

   Result	Proceed to
   DTCs B1630/23 and B1635/24 are not output.	A
   DTC B1630/23 is output.	B
   DTC B1635/24 is output.	C

   HINT: 

   Codes other than DTCs B1630/23 and B1635/24 may be output at this time, but they are not related to this check.

B → See step   4 

C → See step   3 

A → See step   2