LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2013 >> Highlander SE, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Fuel System (1AR-FE) (Service Information) (Except Hybrid)) >> Fuel Sender Gauge Assembly >> Installation >> Installation

Fuel Sender Gauge Assembly: Installation: Installation

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL FUEL SENDER GAUGE ASSEMBLY 
    1. Slide the fuel sender gauge to fit the claw.
      Fig 1: Installing Fuel Sender Gauge Assembly With Claw
      GTY189703Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE 
    1. Install the fuel suction tube assembly with pump and gauge. Refer to INSTALLATION .
scientia non olet · About LEMON Manuals