Front Crankshaft Oil Seal: Installation: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL TIMING CHAIN COVER OIL SEAL
1. Apply MP grease to the lip of a new oil seal.
  NOTE:
  - Do not allow foreign matter to contact the lip of the oil seal.
  - Do not allow MP grease to contact the dust seal.
2. Using SST and a hammer, tap in the oil seal until its surface is flush with the timing chain cover edge.
  
  Fig 1: Installing Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  - SST: 09223-22010
  NOTE:
  - Keep the lip of the oil seal free from foreign matter.
  - Do not tap in the oil seal at an angle.
INSTALL CRANKSHAFT PULLEY
1. Align the pulley set key with the key groove of the crankshaft pulley.
2. Using SST, hold the crankshaft pulley and install the pulley bolt.
  
  Fig 2: Holding Crankshaft Pulley
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  - SST: 09213-54015
  - SST: 91551-80650
  - SST: 09330-00021
  Torque: 260 N*m (2651 kgf*cm, 192 ft.*lbf)
INSTALL V-RIBBED BELT See step 1
INSTALL FRONT FENDER APRON SEAL RH See step 80
INSTALL FRONT FENDER LINER RH . Refer to INSTALLATION - Step 2
INSTALL FRONT FENDER MOLDING SUB-ASSEMBLY RH See step 4
INSTALL NO. 1 ENGINE UNDER COVER
INSTALL FRONT WHEEL RH
Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf)