LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2013 >> Highlander SE, AWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> (Door / Hatch) (Service Information) (Except Hybrid) >> Power Back Door Drive Unit >> Reassembly >> Reassembly

Power Back Door Drive Unit: Reassembly: Reassembly

  1. INSTALL BACK DOOR UPPER ROD 
    1. Clamp a new power back door arm sub-assembly in a vise between aluminum plates.
      Fig 1: Identifying Power Back Door Arm Sub-Assembly And Nut
      GTY374055Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the power back door arm sub-assembly with a new nut.

      Torque: 74 N*m (754 kgf*cm, 55 ft.*lbf) 

    3. Attach the ball joint to install a new power back door rod.
      Fig 2: Identifying Power Back Door Arm Sub-Assembly
      GTY369445Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals