LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2013 >> Avalon XLE >> Repair and Diagnosis >> Electrical >> Motors, Switches, Relays >> Wireless Charging System (Diagnostics & Circuit Tests) (Except Hybrid) >> Wireless Charging System >> Circuit Tests >> Wireless Charger Power Source Circuit >> Procedure

Wireless Charger Power Source Circuit: Procedure

  1. CHECK HARNESS AND CONNECTOR (MOBILE WIRELESS CHARGER CRADLE ASSEMBLY POWER SOURCE) 
    1. Disconnect the D118 mobile wireless charger cradle assembly connector.
    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      D118-5 (PGND) - Body ground Always Below 1 Ω
    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage

      Tester Connection Condition Specified Condition
      D118-1 (ACC) - D118-5 (PGND) Engine switch on (ACC) 11 to 14 V

    NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK → See step   2 

  2. PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE  
scientia non olet · About LEMON Manuals