Main Switch Signal Circuit: Procedure
- INSPECT MOBILE WIRELESS CHARGER SWITCH
- Remove the mobile wireless charger switch. Refer to REMOVAL .
- Measure the resistance according to the value(s) in the table below.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Standard Resistance
Tester Connection Condition Specified Condition 11 (+B) - 8 (D) Mobile wireless charger switch is on (not protruding) Below 1 Ω Mobile wireless charger switch is off (protruding) 10 kΩ or higher TEXT IN ILLUSTRATION*a Component without harness connected
(Mobile Wireless Charger Switch)
NG → See step 3
OK → See step 2
- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE
- REPLACE MOBILE WIRELESS CHARGER SWITCH. Refer to REMOVAL