Entire Combination Meter does not Operate: Procedure

1. Disconnect the D9 combination meter assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   D9-7 (ES) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   D9-13 (IG+) - Body ground	Engine switch off	Below 1 V
   	Engine switch on (IG)	11 to 14 V
   D9-1 (B) - Body ground	Always	11 to 14 V

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   2