CD Sound Skips: Procedure

1. Check that the CD is not deformed or cracked.
   Fig 1: Identifying Deformed Or Cracked Discs

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   OK

   No deformation or cracks on the CD

NG → END (CD IS FAULTY) 

OK: Go to next step 

1. Check the CD.
   Fig 2: Identifying Wiping Direction Of Disc Surface With Soft Dry Cloth

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   OK

   The CD is clean.

   NOTE:

   Do not use a conventional record cleaner or anti-static preservative.

   HINT: 

   If dirt is on the CD surface, wipe it clean with a soft cloth from the inside to the outside in a radial direction.

NG → CLEAN CD 

OK: Go to next step 

1. Replace the CD with a known good one and check that the malfunction disappears.

   OK

   Malfunction disappears.

NG → See step   4 

OK → END (CD WAS FAULTY) 

1. Check the radio and display receiver assembly installation condition.
   1. Check that the radio and display receiver assembly is properly installed.

      OK

      The radio and display receiver assembly is properly installed.

NG → REINSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY PROPERLY 

OK → See step   5