Hazard Warning Switch Circuit: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Data List.
5. Read the display on the Techstream.
   COMBINATION METER
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Hazard Flasher Switch	Hazard warning signal switch signal/ON or OFF	ON: Hazard warning signal switch on OFF: Hazard warning signal switch off	-

   OK

   Normal conditions listed above are displayed.

NG → See step   2 

OK → See step   5 

1. Remove the hazard warning signal switch assembly. Refer to REMOVAL .
2. Inspect the hazard warning signal switch assembly. Refer to INSPECTION .

NG → See step   6 

OK: Go to next step 

1. Disconnect the D8 combination meter assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   D53-4 (F) - D8-5 (HAZ)	Always	Below 1 Ω
   D53-4 (F) - Body ground	Always	10 kΩ or higher
   D53-1 (E) - Body ground	Always	Below 1 Ω

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   4