Brake Shoes &/Or Pads: Remove & Replace
WARNING: This page is about the Yaris Base, Automatic Trans, which is a different variant/trim than selected.
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable).
Includes: Repack Wheel Bearings (where applicable).
DOES NOT include refinishing.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| All,w/Rear Disc Brakes | 1.8 | B | ||
| All,w/Rear Drum Brakes | 2.2 | B | ||
| Front,Both Sides | 1.0 | B | ||
| Rear,w/Rear Disc Brakes,Both Sides | 1.0 | B | ||
| Rear,w/Rear Drum Brakes,Both Sides | 1.4 | B | ||
| Combination Procedure: BRAKE HOSE: Replace: | ||||
| Each Additional | 0.2 | B | ||
| One | Includes: Bleed Brakes. | 0.3 | B | |
| Combination Procedure: CALIPER: Overhaul: | ||||
| One | Includes: Bleed Brakes. | 0.5 | B | |
| Combination Procedure: CALIPER: Replace: | ||||
| One | Includes: Bleed Brakes. | 0.3 | B | |
| Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle: | ||||
| 0.5 | B | |||
| Combination Procedure: DISC ROTOR: Correct: | ||||
| Lateral Runout,Each | Correct Rotor lateral runout by indexing. | 0.2 | B | |
| Combination Procedure: HUB & ROTOR DISC: Clean & Inspect: | ||||
| Corrosion,Each | Clean any rust or corrosion from mating surface of Hub/Axle Flange and Brake Rotor. | 0.2 | B | |
| Combination Procedure: PARKING BRAKE SHOE & LINING: Replace: Includes: Clean, lube and/or replace Parking Brake Hardware (as necessary). DOES NOT include refinishing. | ||||
| Each Side | 0.4 | B | ||
| Combination Procedure: WHEEL BEARING: Replace: | ||||
| Sedan, Front,One Side | 1.8 | B | ||
| Sedan, Rear,One Side | 0.8 | B | ||
| Combination Procedure: WHEEL CYLINDER: Overhaul: | ||||
| One, Off Vehicle | Includes: Bleed Brakes. | 0.5 | B | |
| One, On Vehicle | Includes: Bleed Brakes. | 0.3 | B | |
| Combination Procedure: WHEEL CYLINDER: Replace: | ||||
| One | Includes: Bleed Brakes. | 0.3 | B | |