Tachometer Malfunction: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch ON and turn the tester ON.
3. Enter the following menus: Body Electrical / Combination Meter /Active Test.

   Body Electrical / Combination Meter / Active Test:

   Tester Display	Test Part	Control Range	Diagnostic Note
   Tachometer Operation	Tachometer	0/1000/2000/3000/4000/5000/6000/7000 RPM	-

   OK

   Engine speed displayed on the tester is approximately the same as that of the tachometer reading.

NG → See step   5 

OK: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch ON and turn the tester ON.
3. Select the item below from the Data List, and read the value displayed on the Techstream.

   Body Electrical / Combination Meter / Data List:

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Engine RPM	Engine speed/Min.: 0 RPM, Max.: 12, 750 RPM	Approximately same as actual engine speed (When engine is running)	-

   OK

   Engine speed displayed on the tester is approximately the same as the actual engine speed.

NG → See step   4 

OK → See step   3