Driver Side Seat Belt Warning Light does not Operate: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch ON and turn the tester ON.
3. Enter the following menus: Body Electrical / SRS Airbag / Trouble Codes.

   Result

   Result	Proceed to
   No SRS DTCs are output	A
   SRS DTCs are output	B

B → See step   4 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch ON and turn the tester ON.
3. Enter the following menus: Body Electrical / Combination Meter / Active Test.

   Body Electrical / Combination Meter / Active Test:

   Tester Display	Test Part	Control Range	Diagnostic Note
   Driver Side Seat Belt	Driver side seat belt warning light	OFF/ON	Vehicle is stopped and engine is idling

   OK

   Front driver seat belt warning light comes on.

OK → REPLACE MAIN BODY ECU 

NG → See step   3