Valve Body Assembly: Removal: Removal

WARNING: This page is about a different variant/trim than selected.

REMOVE AUTOMATIC TRANSAXLE ASSEMBLY
Refer to REMOVAL
REMOVE TORQUE CONVERTER CLUTCH ASSEMBLY See step 5
REMOVE AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY
1. Remove the 19 bolts and automatic transaxle oil pan from the transaxle case.
  
  Fig 1: Identifying Automatic Transaxle Oil Pan Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  NOTE:
  Some fluid will remain in the automatic transaxle oil pan. Remove all the bolts, and carefully remove the automatic transaxle oil pan.
REMOVE AUTOMATIC TRANSAXLE OIL PAN GASKET
1. Remove the automatic transaxle oil pan gasket.

REMOVE TRANSMISSION OIL CLEANER MAGNET

Remove the 2 transmission oil cleaner magnets from the automatic transaxle oil pan.

Fig 2: Identifying Transmission Oil Cleaner Magnets
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
TEXT IN ILLUSTRATION

*1 Transmission Oil Cleaner Magnet

Examine particles in the automatic transaxle oil pan.

Fig 3: Inspecting For Chips And Steel Particles In Pan

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Collect any steel chips with the removed magnets. Look carefully at the chips and particles in the automatic transaxle oil pan and on the transmission oil cleaner magnets to see the type of wear which might be found in the automatic transaxle.

RESULT

Steel (magnetic)	Brass (non-magnetic)
Bearing, gear and plate wear	Bushing wear

REMOVE VALVE BODY OIL STRAINER ASSEMBLY
1. Remove the 2 bolts and valve body oil strainer from the transmission valve body.
  
  Fig 4: Identifying Oil Strainer Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the O-ring from the valve body oil strainer.
  
  Fig 5: Identifying Valve Body Oil Strainer & O-Ring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE TRANSMISSION VALVE BODY ASSEMBLY
1. Remove the 11 bolts and transmission valve body from the transaxle case.
  
  Fig 6: Identifying Transaxle Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  NOTE:
  When removing the transmission valve body, be careful not to allow the transmission revolution sensor and the transaxle case to interfere with each other.
REMOVE NO. 1 GOVERNOR APPLY GASKET
1. Remove the 2 No. 1 governor apply gaskets from the transaxle case.
  
  Fig 7: Identifying Transaxle Case Gasket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE MANUAL VALVE
1. Remove the manual valve from the transmission valve body.
  
  Fig 8: Identifying Manual Valve
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002