DIFFERENTIAL OIL SEAL (for RH Side): Replacement: Replacement

WARNING: This page is about a different variant/trim than selected.

REMOVE TRANSFER ASSEMBLY
Refer to REMOVAL
REMOVE FRONT TRANSAXLE CASE OIL SEAL
1. Using a screwdriver with its tip wrapped with protective tape, remove the front transaxle case oil seal.
  
  Fig 1: Removing Front Transaxle Case Oil Seal (Outside)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  TEXT IN ILLUSTRATION
  
  *1 Protective Tape
REMOVE FRONT DIFFERENTIAL CASE OIL SEAL
1. Using SST, tap out the front differential case oil seal.
  
  Fig 2: Removing Front Transaxle Case Oil Seal (Inside)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  - SST: 09308-00010
INSTALL FRONT TRANSAXLE CASE OIL SEAL
1. Coat the lip of the front transaxle case oil seal with MP grease.
  
  Fig 3: Installing Front Transaxle Case Oil Seal (Outside)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using SST and a hammer, tap in a new front transaxle case oil seal.
  - SST: 09649-17010
  - SST: 09950-70010
    1. 09951-07200
  Oil seal driven in depth
  
  5.5 to 6.5 mm (0.217 to 0.255 in.)
  
  NOTE:
  Check that the oil seal is installed in the correct direction.
INSTALL FRONT DIFFERENTIAL CASE OIL SEAL
1. Coat the lip of the front transaxle case oil seal with MP grease.
2. Using SST and a hammer, tap in the front transaxle case oil seal.
  
  Fig 4: Installing Front Transaxle Case Oil Seal (Inside)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  - SST: 09950-60010
    1. 09951-00410
  - SST: 09950-70010
    1. 09951-07200
  Oil seal driven in depth
  
  21.5 to 22.5 mm (0.847 to 0.885 in.)
  
  NOTE:
  Check that the oil seal is installed in the correct direction.
INSTALL TRANSFER ASSEMBLY
Refer to INSTALLATION