Meter Illumination is Always Dark: Procedure

1. Check if a CAN communication DTC is output. Refer to DIAGNOSIS SYSTEM .
   RESULT
   
   

   Result	Proceed to
   CAN communication DTC is not output.	A
   CAN communication DTC is output.	B

B → See step   6 

A: Go to next step 

1. Check if DTC B1244 is output. Refer to DTC CHECK / CLEAR .
   RESULT
   
   

   Result	Proceed to
   B1244 is not output.	A
   B1244 is output.	B

B → See step   7 

A: Go to next step 

1. Turn the ignition switch to ON.
2. Turn the light control switch to the tail, head or AUTO position.
3. Cover the automatic light control sensor.
4. Check the accessory meter assembly illumination.
   RESULT
   
   

   Result	Proceed to
   Accessory meter assembly illumination does not operate normally.	A
   Accessory meter assembly illumination operates normally.	B

   HINT: 

   The accessory meter assembly illumination dims according to the dimmer signal as the combination meter assembly does. Therefore, when only the meter illumination is always dark, there may be a malfunction in the combination meter assembly.

B → See step   8 

A: Go to next step 

1. Turn the ignition switch to ON.
2. Turn the light control switch to the AUTO position.
3. Cover the automatic light control sensor.
4. Check the taillights and low beam headlights.

   OK

   The taillights and low beam headlights come on.

5. Uncover the automatic light control sensor.
6. Check the low beam headlights and taillights.

   OK

   The low beam headlights and taillights go off.

   RESULT
   
   

   Result	Proceed to
   Automatic light control system operates normally.	A
   Automatic light control system does not operate normally.	B

B → See step   9 

A: Go to next step 

1. Replace the main body ECU with a new or a normal one. Refer to REMOVAL .

   OK

   The operation of the combination meter assembly returns to normal.

   HINT: 

   The meter CPU controls the meter illumination based on an auto dimmer signal from the main body ECU. When the meter illumination is always dark (very dim), it may be due to the main body ECU sending an auto dimmer signal to the meter CPU because of a malfunction in the main body ECU.

NG → See step   8 

OK → END