Rocker Panel Moulding: Removal: Removal

HINT: 

• Use the same procedure for the RH and LH sides.
• The procedure described below is for the LH side.

1. REMOVE ROCKER PANEL MOULDING END FRONT COVER 

   Refer to REMOVAL 

2. REMOVE BODY ROCKER PANEL MOULDING ASSEMBLY 
   Fig 1: Identifying Body Rocker Panel Moulding Assembly Fasteners

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   1. Remove the 2 screws.
   2. Remove the screw.
      Fig 2: Identifying Upper Body Rocker Panel Moulding Assembly Fastener

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. Remove the screw grommet.
      Fig 3: Identifying Upper Body Rocker Panel Moulding Assembly Grommet

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT: 

      The grommet needs to be replaced with a new one because it will break when it is removed.

   4. Remove the screw.
      Fig 4: Identifying Upper Body Rocker Panel Moulding Assembly Fastener

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   5. Remove the 6 clips.
      Fig 5: Identifying Lower Body Rocker Panel Moulding Assembly Clips

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   6. Disengage the 7 clips and remove the body rocker panel moulding.
      Fig 6: Identifying Body Rocker Panel Moulding Assembly Clips

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002