POWER SLIDE DOOR CONTROL SWITCH (for Roof Side): Inspection: Inspection

INSPECT POWER SLIDE DOOR CONTROL SWITCH

Check that the power slide door control switch RH functions.

Measure the resistance according to the value(s) in the table below.

Fig 1: Power Slide Door Control Switch (For Roof Side) Connector End View

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

TEXT IN ILLUSTRATION

*a	Component without harness connected (Roof Console Box Assembly)

Standard Resistance

Terminal No.	Switch Condition	Specified Condition
1 (GND) - 18 (CSW)	Pushed	Below 1 Ω
1 (GND) - 18 (CSW)	Free	10 kΩ or higher

If the result is not as specified, replace the roof console box assembly.

Check that the power slide door control switch LH functions.

Measure the resistance according to the value(s) in the table below.

Standard Resistance

Terminal No.	Switch Condition	Specified Condition
1 (GND) - 16 (CSW)	Pushed	Below 1 Ω
1 (GND) - 16 (CSW)	Free	10 kΩ or higher

If the result is not as specified, replace the roof console box assembly.

Check that the switch illuminates.

Apply battery voltage to the power slide door control switch and check that the switch illuminates.

Measurement Condition	Specified Condition
Battery positive (+) → 10 (ILL+) Battery negative (-) → 2 (ILL-)	Illuminates

If the result is not as specified, replace the roof console box assembly.