Driver Side Seat Belt Warning Light does not Operate: Procedure
- CHECK DTC OUTPUT (CAN COMMUNICATION SYSTEM)
- Clear the DTC. Refer to HOW TO PROCEED WITH TROUBLESHOOTING .
- Recheck for DTCs.RESULT
Result Proceed to DTC is not output A DTC is output B
B → See step 4
A: Go to next step
- CHECK DTC OUTPUT (AIRBAG SYSTEM)
- Clear the DTC. Refer to DTC CHECK / CLEAR .
- Recheck for DTCs.RESULT
Result Proceed to DTC is not output A DTC is output B
B → See step 5
A: Go to next step
- PERFORM ACTIVE TEST USING TECHSTREAM (DRIVER SIDE SEAT BELT)
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Combination Meter / Active Test.
- According to the display on the Techstream, perform the Active Test.COMBINATION METER
Tester Display Test Part Control Range Diagnostic Note Driver Side Seat Belt Driver side seat belt warning light OFF or ON Confirm that the vehicle stopped with the engine idling OK
The driver side seat belt warning light on the combination meter assembly operates normally.
NG → See step 6
OK → See step 7
- GO TO CAN COMMUNICATION SYSTEM. Refer to HOW TO PROCEED WITH TROUBLESHOOTING
- GO TO AIRBAG SYSTEM. Refer to DIAGNOSTIC TROUBLE CODE CHART
- REPLACE COMBINATION METER ASSEMBLY. Refer to REMOVAL
- USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING