ULTRASONIC SENSOR (for Rear Side): Removal: Removal

REMOVE REAR BUMPER COVER
Refer to REMOVAL
REMOVE NO. 1 ULTRASONIC SENSOR (for Back Sensor)

Fig 1: Locating No. 1 Ultrasonic Sensor Connector (For Back Sensor)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Disconnect the connector.
  HINT:
  
  Use the same procedure for the remaining parts.
2. Disengage the 2 claws as shown in the illustration and release the lock and remove the No. 1 ultrasonic sensor.
  
  Fig 2: Identifying No. 1 Ultrasonic Sensor Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  HINT:
  
  Use the same procedure for the remaining parts.
REMOVE NO. 1 ULTRASONIC SENSOR RETAINER (for Back Sensor)

Fig 3: Identifying No. 1 Ultrasonic Sensor Retainer Claws (For Back Sensor)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Disengage the 2 claws and remove the No. 1 ultrasonic sensor retainer.
  HINT:
  
  Use the same procedure for the remaining parts.
REMOVE NO. 1 ULTRASONIC SENSOR (for Corner Sensor)

Fig 4: Identifying No. 1 Ultrasonic Sensor Connector (For Corner Sensor)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Disconnect the connector.
  HINT:
  
  Use the same procedure for the remaining parts.
2. Disengage the 2 claws as shown in the illustration and release the lock and remove the No. 1 ultrasonic sensor.
  
  Fig 5: Identifying Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  HINT:
  
  Use the same procedure for the remaining parts.
REMOVE NO. 2 ULTRASONIC SENSOR RETAINER (for Corner Sensor)

Fig 6: Identifying No. 2 Ultrasonic Sensor Retainer Claws (For Corner Sensor)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Disengage the 2 claws and remove the No. 2 ultrasonic sensor retainer.
  HINT:
  
  Use the same procedure for the remaining parts.