Inspection Procedure

NOTE:

When there is a malfunction in the auto access seat, use independent operation mode to ingress the auto access seat. In this case, until the auto access seat has completed the ingress operation, do not disconnect the cable from the negative battery terminal.
When another DTC for the auto access seat system is also output, first conduct diagnosis for that DTC using the flowchart. Refer to DIAGNOSTIC TROUBLE CODE CHART .
When there is a malfunction in the auto access seat, before beginning the troubleshooting procedure, first perform initialization. Refer to INITIALIZATION and verify the auto access seat operation. If the seat is still malfunctioning, perform the troubleshooting procedure.
After performing initialization, be sure to inspect the operation of the auto access seat. Refer to OPERATION CHECK .