Vanity Light: Removal: Removal

HINT: 

• Use the same procedure for both the RH and LH sides.
• The procedure described below is for the RH side.

1. REMOVE VISOR ASSEMBLY 
   1. Using a moulding remover, disengage the 4 claws and remove the visor cover.
      Fig 1: Removing Visor Assembly Visor Cover Using Moulding Remover

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      TEXT IN ILLUSTRATION
      
      

      *1	Moulding Remover

   2. Using a T20 "TORX" socket wrench, remove the 3 screws.
      Fig 2: Removing Visor Assembly Fasteners

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. Disconnect the connector and remove the visor.