LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2012 >> Sienna SE >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Infotainment >> Navigation System (For DVD Without USB Audio System) (Diagnostic Codes & Circuit Tests) >> NAVIGATION SYSTEM (for DVD without USB Audio System) >> Symptom Tests >> Vehicle Position Mark Deviates Greatly >> Procedure

Vehicle Position Mark Deviates Greatly: Procedure

  1. CHECK GPS MARK 
    1. Check that the GPS mark is displayed.
      Fig 1: Checking GPS Mark Is Displayed
      GTY207291Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      OK

      GPS mark is displayed.

    NG → See step   2 

    OK: Go to next step 

  2. GO TO "GPS MARK IS NOT DISPLAYED" IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE 
  3. CHECK VEHICLE SENSOR (NAVIGATION CHECK MODE) 
    1. Enter the "Navigation Check" mode and select "Vehicle Sensors". Refer to OPERATION CHECK .
      Fig 2: Screen Display - Navigation Check Mode
      GTY108366Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. While driving the vehicle, compare the "Speed" indicator to the reading on the speedometer. Check that these readings are equal or almost equal.

      OK

      The readings are equal or almost equal.

    NG → See step   4 

    OK: Go to next step 

  4. GO TO "SPEED SIGNAL DOES NOT CHANGE IN NAVIGATION CHECK MODE" IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE 
  5. CHECK VEHICLE SENSOR (NAVIGATION CHECK MODE) 
    1. Check that the display changes between ON and OFF according to the shift lever operation.
      Fig 3: Screen Display - Shift Lever Operation
      GTY108367Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      OK

      Shift Lever Position Condition Display Condition
      Except R OFF
      R ON

      HINT: 

      The display is updated once per second. It is normal for the display to lag behind the actual shift lever operation.

    NG → See step   6 

    OK → END 

  6. GO TO "REVERSE SIGNAL DOES NOT CHANGE IN THE NAVIGATION CHECK MODE" IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE