LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2012 >> Sienna SE >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Infotainment >> Navigation System (For DVD With USB Audio System) (Diagnostic Codes & Circuit Tests) >> NAVIGATION SYSTEM (for DVD with USB Audio System) >> Symptom Tests >> Does not Play even after Bluetooth Audio Mode is Selected >> Procedure

Does not Play even after Bluetooth Audio Mode is Selected: Procedure

  1. CHECK OPERATION 
    1. Check if the portable player operates normally.

      OK

      The portable player operates normally.

    NG → MALFUNCTION IN PORTABLE PLAYER 

    OK: Go to next step 

  2. CHECK AUDIO SETTINGS 
    1. Enter the "Sound Settings" screen by pressing the "Sound" switch on the audio display.
      Fig 1: Screen Display - Sound Settings
      GTY185508Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Set volume, fader and balance to the initial values and check that sound is normal.

      OK

      Audio system returns to normal.

      HINT: 

      Sound quality adjustment measures vary according to the type of the amplifier.

    NG → See step   5 

    OK: Go to next step 

  3. CHECK USING ANOTHER "BLUETOOTH" AUDIO COMPATIBLE VEHICLE OF SAME MODEL 
    1. Check if the portable player plays normally on another "Bluetooth" audio compatible vehicle of the same model.

      OK

      The portable player operates normally.

    NG → MALFUNCTION IN PORTABLE PLAYER 

    OK → See step   4 

  4. PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE 
  5. REPLACE NAVIGATION RECEIVER ASSEMBLY. Refer to  REMOVAL