DTC CB-52: No Playable iPod File Exists; DTC CB-7E: No Playable USB File Exists: Procedure

1. Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.
2. Check if playable files are present on the USB device or "iPod".

   HINT: 

   Refer to System Description for playable files. Refer to SYSTEM DESCRIPTION .

   RESULT
   
   

   Result	Proceed to
   No playable files exist	A
   Playable files exist	B

B → See step   2 

A → END 

1. Turn the ignition switch off.

   HINT: 

   When one of these DTCs has been stored, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.

2. Turn the ignition switch to ACC.
3. Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.

NEXT: Go to next step 

1. Clear the DTCs. Refer to DTC CHECK / CLEAR .

NEXT: Go to next step 

1. Recheck for DTCs and check if the same DTC occurs again.

   HINT: 

   If DTCs are detected frequently, replace the multi-media interface ECU.

   OK

   Malfunction disappears.

NG → See step   5 

OK → END (USB DEVICE OR "iPod" WAS DEFECTIVE)