POWER WINDOW REGULATOR MOTOR (for Rear Door): Inspection: Inspection
- INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
- Apply positive (+) battery voltage to connector terminal 2 (B).
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
NOTE:Do not apply positive (+) battery voltage to any terminals other than terminal 2 (B) to avoid damaging the pulse sensor inside the motor.
- Connect a ground lead to connector terminals 1 (GND) and 7 (DOWN) or 10 (UP).
- Check that the motor gear rotates smoothly as follows:
OK
Measurement Condition Specified Condition - Connect a positive (+) battery lead to terminal 2 (B), connect a negative (-) battery lead to terminal 1 (GND), and keep them connected for 3 seconds or more.
- With terminals 2 (B) and 1 (GND) connected, connect a negative (-) battery lead to terminal 10 (UP).
- Disconnect and reconnect a negative (-) battery lead to terminal 10 (UP) within 1 second.
Motor gear rotates clockwise (Up) - Connect a positive (+) battery lead to terminal 2 (B), connect a negative (-) battery lead to terminal 1 (GND), and keep them connected for 3 seconds or more.
- With terminals 2 (B) and 1 (GND) connected, connect a negative (-) battery lead to terminal 7 (DOWN).
- Disconnect and reconnect a negative (-) battery lead to terminal 7 (DOWN) within 1 second.
Motor gear rotates counterclockwise (Down) TEXT IN ILLUSTRATION*a Component without harness connected
(to Power Window Regulator Motor LH)- If the result is not as specified, replace the power window regulator motor LH.
WARNING:Reset the power window regulator motor (initialize the pulse sensor) after installing the power window regulator motor and regulator onto the door.
- Apply positive (+) battery voltage to connector terminal 2 (B).
- INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH
- Apply positive (+) battery voltage to connector terminal 2 (B).
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
NOTE:Do not apply positive (+) battery voltage to any terminals other than terminal 2 (B) to avoid damaging the pulse sensor inside the motor.
- Connect a ground lead to connector terminals 1 (GND) and 7 (DOWN) or 10 (UP).
- Check that the motor gear rotates smoothly as follows:
OK
Measurement Condition Specified Condition - Connect a positive (+) battery lead to terminal 2 (B), connect a negative (-) battery lead to terminal 1 (GND), and keep them connected for 3 seconds or more.
- With terminals 2 (B) and 1 (GND) connected, connect a negative (-) battery lead to terminal 10 (UP).
- Disconnect and reconnect a negative (-) battery lead to terminal 10 (UP) within 1 second.
Motor gear rotates counterclockwise (Up) - Connect a positive (+) battery lead to terminal 2 (B), connect a negative (-) battery lead to terminal 1 (GND), and keep them connected for 3 seconds or more.
- With terminals 2 (B) and 1 (GND) connected, connect a negative (-) battery lead to terminal 7 (DOWN).
- Disconnect and reconnect a negative (-) battery lead to terminal 7 (DOWN) within 1 second.
Motor gear rotates clockwise (Down) TEXT IN ILLUSTRATION*a Component without harness connected
(to Power Window Regulator Motor RH)- If the result is not as specified, replace the power window regulator motor RH.
WARNING:Reset the power window regulator motor (initialize the pulse sensor) after installing the power window regulator motor and regulator onto the door.
- Apply positive (+) battery voltage to connector terminal 2 (B).