DTC B2414: Steering Position Sensor Malfunction: Procedure

CHECK FOR DTC
1. Clear the DTCs. Refer to DTC CHECK / CLEAR .
2. Check for DTCs. Refer to DTC CHECK / CLEAR .
  OK
  
  DTC B2414 is not output.
NG → See step 2

OK → See step 4
REPLACE STEERING ANGLE SENSOR
1. Temporarily replace the steering angle sensor with a new or normally functioning one. Refer to REMOVAL .
NEXT: Go to next step
CHECK FOR DTC
1. Clear the DTCs. Refer to DTC CHECK / CLEAR .
2. Check for DTCs. Refer to DTC CHECK / CLEAR .
  OK
  
  DTC B2414 is not output.
NG → See step 5

OK → END
USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING
REPLACE HEADLIGHT SWIVEL ECU ASSEMBLY. Refer to REMOVAL