Entire Combination Meter does not Operate: Procedure

1. Disconnect the D18 combination meter assembly connector.
   Fig 1: D18 Combination Meter Assembly Connector End View

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Switch Condition	Specified Condition
   D18-21 (IG+) - Body ground	Ignition switch ON	11 to 14 V
   D18-1 (B) - Body ground	Always	11 to 14 V
   D18-2 (B2) - Body ground	Always	11 to 14 V

3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   D18-20 (ES) - Body ground	Always	Below 1 Ω

   TEXT IN ILLUSTRATION
   
   

   *a	Front view of wire harness connector (to Combination Meter Assembly)

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   2