DTC B15C0: Short in GPS Antenna; DTC B15C1: Open in GPS Antenna: Procedure

1. Turn the ignition switch off.
2. Connect the Techstream to the DLC3.
3. Turn the ignition switch to ON and wait for 10 seconds.
4. Turn the Techstream on.
5. Perform "HEALTH CHECK" and check for current DTCs. Refer to HEALTH CHECK .
   RESULT
   
   

   Result	Proceed to
   DTC B15C0 or B15C1 is output	A
   DTC B15C0 or B15C1 is not output	B

B → See step   6 

A: Go to next step 

1. Disconnect the B DCM (Telematics Transceiver) connector.
   Fig 1: Inspecting Telephone And GPS Antenna Cord (Antenna Cord Sub-Assembly - Vehicle's Wire Harness)

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the D telephone and GPS antenna assembly connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   B-1 - D-2	Always	Below 1 Ω
   B-1a - D-2a	Always	Below 1 Ω
   B-1 - Body ground	Always	10 kΩ or higher
   B-1a - Body ground	Always	10 kΩ or higher

   TEXT IN ILLUSTRATION
   
   

   *1	Telephone and GPS Antenna Cord (Antenna Cord Sub-Assembly)
   *2	Telephone and GPS Antenna Cord (Vehicle's Wire Harness)
   *a	B Connector Color: Gray
   *b	D Connector Color: Blue

NG → See step   5 

OK: Go to next step 

1. Replace the telephone and GPS antenna assembly with a normal one and check if the same problem occurs again. Refer to REMOVAL .

   OK

   The system returns to normal.

NG → See step   4 

OK → END 

1. Replace the DCM (Telematics Transceiver). Refer to REMOVAL .
   NOTE:

   • The ignition switch must be off.
   • Do not swap the DCM (Telematics Transceiver) with one from another vehicle.

NEXT → See step   7 

1. Disconnect the B DCM (Telematics Transceiver) connector.
   Fig 2: Inspecting Telephone And GPS Antenna Cord (Antenna Cord Sub-Assembly)

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the C telephone and GPS antenna cord (Vehicle's wire harness) connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   B-1 - C-2	Always	Below 1 Ω
   B-1a - C-2a	Always	Below 1 Ω
   B-1 - Body ground	Always	10 kΩ or higher
   B-1a - Body ground	Always	10 kΩ or higher

   TEXT IN ILLUSTRATION
   
   

   *1	Telephone and GPS Antenna Cord (Antenna Cord Sub-Assembly)
   *2	Telephone and GPS Antenna Cord (Vehicle's Wire Harness)
   *a	B Connector Color: Gray
   *b	C Connector Color: Blue

NG → See step   8 

OK → REPLACE TELEPHONE AND GPS ANTENNA CORD (VEHICLE'S WIRE HARNESS)