Engine Coolant Temperature Receiver Gauge Malfunction: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Active Test.
5. Check the operation by referring to the values in the table below.
   COMBINATION METER:
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Water Temperature Meter Operation	Engine coolant temperature receiver gauge	Low, Normal, Hi	-

   OK

   Needle indication is normal.

NG → REPLACE COMBINATION METER ASSEMBLY 

OK: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Data List.
5. Check the values by referring to the table below.
   COMBINATION METER:
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Coolant Temperature	Engine coolant temperature/Min.: 0°C (32°F), Max.: 127.5°C (261.5°F)	After warming up: 80 to 100°C (176 to 212°F)	If -40°C (-40°F): Sensor circuit open If 140°C (284°F) or more: Sensor circuit shorted

   OK

   Engine coolant temperature value displayed on the tester is almost the same as needle indication.

NG → REPLACE COMBINATION METER ASSEMBLY 

OK → GO TO SFI SYSTEM