LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2012 >> Prius V >> Repair and Diagnosis >> Hybrid/Electric Powertrain >> Testing and Diagnosis >> Hybrid Control System [Diagnostic Codes (P0AA4-232 - U0424-537) & Circuit Tests] >> Hybrid Control System >> DTC P0AC0-817: Hybrid Battery Pack Current Sensor Circuit Range / Performance >> Procedure

DTC P0AC0-817: Hybrid Battery Pack Current Sensor Circuit Range / Performance: Procedure

  1. CHECK DTC OUTPUT (HYBRID CONTROL) 
    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
    4. Check if DTCs are output.

      Result

      Result Proceed to
      P0AC0-817 only is output. A
      P0AFC-123 is output. B
    5. Turn the power switch off.

    B → See step   7 

    A: Go to next step 

  2. REPLACE HYBRID BATTERY JUNCTION BLOCK ASSEMBLY 

    Refer to COMPONENTS

    NEXT: Go to next step 

  3. CLEAR DTC 
    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
    4. Read and record the DTCs and freeze frame data.
    5. Clear DTCs and freeze frame data.
    6. Turn the power switch off.

    NEXT: Go to next step 

  4. PERFORM ROAD TEST 
    1. Perform a road test.

    NEXT: Go to next step 

  5. CHECK DTC OUTPUT (HYBRID CONTROL) 
    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
    4. Check if DTCs are output.

      Result

      Result Proceed to
      P0AC0-817 is not output. A
      P0AC0-817 is output again. B
    5. Turn the power switch off.

    B → See step   6 

    A → COMPLETED 

  6. REPLACE BATTERY SMART UNIT. Refer to  COMPONENTS 
  7. GO TO DTC CHART (P0AFC-123). Refer to  DTC P0AFC-123: Hybrid Battery Pack Sensor Module 
scientia non olet · About LEMON Manuals