Entire Combination Meter does not Operate: Procedure

1. Disconnect the L27 connector.
   Fig 1: Identifying Harness And Connector (Combination Meter Assembly Circuit)

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   L27-30 (ES) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   L27-19 (IG+) - Body ground	Power switch off	Below 1 V
   L27-19 (IG+) - Body ground	Power switch on (IG)	11 to 14 V
   L27-18 (B) - Body ground	Power switch off	11 to 14 V

   TEXT IN ILLUSTRATION
   
   

   *1	Front view of wire harness connector (to Combination Meter Assembly (No. 3 Meter Circuit Plate))

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   2