Rear Brake Flexible Hose: Removal: Removal

NOTE:

If both the RH side hose and LH side hose are disconnected at the same time, be sure to place identification marks indicating the position on each side.

HINT:

Use the same procedure for the LH side and RH side.
The following procedure listed is for the LH side.

REMOVE REAR WHEEL
DRAIN BRAKE FLUID
NOTE:
If brake fluid leaks onto any painted surface, immediately wash it off.
REMOVE REAR FLEXIBLE HOSE (for Torsion Beam Type Suspension)
1. Remove the bolt and separate the rear flexible hose from the rear axle beam.
  
  Fig 1: Locating Rear Flexible Hose Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the union bolt and gasket, and separate the rear flexible hose from the rear disc brake cylinder assembly.
  
  Fig 2: Locating Rear Brake Flexible Hose Union Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using a union nut wrench (10 mm), disconnect the brake line while holding the rear flexible hose with a wrench.
  
  Fig 3: Disconnecting Brake Line
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  NOTE:
  - Do not kink or damage the brake line.
  - Do not allow any foreign matter such as dirt and dust to enter the brake line.
4. Remove the clip and rear flexible hose.
  
  Fig 4: Identifying Clip And Rear Flexible Hose
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE REAR FLEXIBLE HOSE (for Double Wishbone Type Suspension)
1. Remove the union bolt and gasket, and separate the rear flexible hose from the rear disc brake cylinder assembly.
  
  Fig 5: Locating Rear Brake Flexible Hose Union Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using a union nut wrench (10 mm), disconnect the brake line while holding the rear flexible hose with a wrench.
  
  Fig 6: Disconnecting Brake Line
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  NOTE:
  - Do not kink or damage the brake line.
  - Do not allow any foreign matter such as dirt and dust to enter the brake line.
3. Remove the clip and rear flexible hose.