LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2012 >> Highlander Limited, FWD >> Repair and Diagnosis >> Suspension >> Wheels & Tire System >> Tire And Wheel (Service Information) (Except Hybrid) >> Tire Pressure Warning Reset Switch >> Removal >> Removal

Tire Pressure Warning Reset Switch: Removal: Removal

WARNING:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing the tire pressure warning reset switch. Refer to PRECAUTION .

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    WARNING:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .

  2. REMOVE FRONT DOOR SCUFF PLATE LH  . Refer to REMOVAL - Step 16
  3. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH  . Refer to REMOVAL - Step 17
  4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for Manual Air Conditioning System)  . Refer to REMOVAL - Step 21
  5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for Automatic Air Conditioning System)  . Refer to REMOVAL - Step 22
  6. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY  . Refer to REMOVAL - Step 7
  7. REMOVE TIRE PRESSURE WARNING RESET SWITCH 
    1. Disengage the 2 claws and remove the tire pressure warning reset switch from the driver side knee airbag.
      Fig 1: Identifying Claws Of Tire Pressure Warning Reset Switch
      GTY188851Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals