LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2012 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 115 (Hybrid Vehicle Control System (Diagnostic Codes (P0ADB-227 - U0424-537) & Circuit Tests)) (Hybrid)) >> Hybrid Control System >> DTC P3004-133: Power Cable Malfunction >> Procedure

DTC P3004-133: Power Cable Malfunction: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. CHECK DTC OUTPUT (HV) 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
    4. Check if DTCs are output.

      Result

      Result Proceed to
      P3004-133 only is output. A
      DTCs other than P3004-133 are output. B
    5. Turn the ignition switch off.

    B → See step   2 

    A → See step   3 

  2. GO TO DTC CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART 
  3. REPLACE HYBRID VEHICLE CONTROL ECU. Refer to  REMOVAL 
scientia non olet · About LEMON Manuals