DTC P1606-308: Collision Detection; DTC P1606-317: Collision Detection: Procedure

1. Check the vehicle condition.

   Result

   Result	Proceed to
   The vehicle is not damaged.	A
   The vehicle is damaged.	B

B → REPAIR VEHICLE 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
4. Check if DTCs are output.

   Result

   Result	Proceed to
   P1606 only is output.	A
   P0A1D is output.	B

5. Turn the ignition switch off.

B → See step   8 

A: Go to next step 

1. Troubleshoot the airbag system. Refer to HOW TO PROCEED WITH TROUBLESHOOTING .

   Result

   Result	Proceed to
   The system is normal.	A
   There is a malfunction in the system.	B

B → REPAIR MALFUNCTIONING PARTS, COMPONENT AND AREA 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
4. Access the freeze frame data of DTC P1606 and read the INF code.

   Result

   Result	Proceed to
   INF code 308 is output.	A
   INF code 317 is output.	B

5. Turn the ignition switch off.

B → See step   6 

A → See step   5 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
4. Check if DTCs are output.

   Result

   Result	Proceed to
   One or two of the following conditions are met.	A
   All of the following conditions are met.	B

   	DTC Output Status
   1	DTC P3107-213 or P3107-214 is output.
   2	DTC U0151-763 is output.
   3	DTC U0110-160 or U0110-657 is output.

5. Turn the ignition switch off.

B → See step   9 

A → See step   7