LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2012 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 115 (Hybrid Vehicle Control System (Diagnostic Codes (P0ADB-227 - U0424-537) & Circuit Tests)) (Hybrid)) >> Hybrid Control System >> DTC P0AFC-150: Hybrid Battery Pack Sensor Module >> Confirmation Driving Pattern

Confirmation Driving Pattern

WARNING: This page is about a different variant/trim than selected.
  1. Connect the Techstream to the DLC3.
  2. Turn the ignition switch to ON and turn the Techstream on.
  3. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
  4. Turn the ignition switch off.
  5. Turn the ignition switch to ON (READY).
  6. Wait for 10 seconds or more.
  7. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
  8. Check that permanent DTCs are cleared.
  9. If the permanent DTCs are not cleared, perform the universal trip, and then check for permanent DTCs again.

    HINT: 

    • If a permanent DTC is output, the system is malfunctioning.
    • If no permanent DTC is output, the system is normal.
scientia non olet · About LEMON Manuals