DTC P0AFC-129: Hybrid Battery Pack Sensor Module: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
4. Check if DTCs are output.

   Result

   Result	Proceed to
   P0AFC-129 only is output.	A
   Any of the following DTCs are also output.	B

   DTC No.	Relevant Diagnosis
   P0A1A-151, 155, 156, 658, 659	Generator Control Module
   P0A1B-164, 193, 512, 661, 786	Drive Motor "A" Control Module
   P0A1D-148	Hybrid Powertrain Control Module
   P0A78-266, 267	Drive Motor "A" Inverter Performance
   P0A94-589, 590	DC / DC Converter Performance
   P2511-149	HV CPU Power Relay Sense Circuit Intermittent No Continuity
   P3004-132	Power Cable Malfunction
   P324E-788	MG-ECU Power Relay Intermittent Circuit
   U0110 (all INF codes)*1	Lost Communication with Drive Motor Control Module "A"

   HINT: 

   • *1: If any INF codes are output for this DTC, refer to the corresponding diagnostic procedure.
   • P0AFC-129 may be output due to a malfunction which causes the DTCs in the table above to be output. In this case, first troubleshoot the output DTCs in the table above. Then, perform a reproduction test to check that no DTCs are output.
5. Turn the ignition switch off.

B → See step   4 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
4. Check if DTCs are output.

   Result

   Result	Proceed to
   P0AFC-129 only is output.	A
   Any of the following DTCs are also output.	B

   DTC No.	Relevant Diagnosis
   P0AFC-123	Hybrid Battery Pack Sensor Module
   P0B3D-123	Hybrid Battery Voltage Sensor "A" Circuit Low
   P0B42-123	Hybrid Battery Voltage Sensor "B" Circuit Low
   P0B47-123	Hybrid Battery Voltage Sensor "C" Circuit Low
   P0B4C-123	Hybrid Battery Voltage Sensor "D" Circuit Low
   P0B51-123	Hybrid Battery Voltage Sensor "E" Circuit Low
   P0B56-123	Hybrid Battery Voltage Sensor "F" Circuit Low
   P0B5B-123	Hybrid Battery Voltage Sensor "G" Circuit Low
   P0B60-123	Hybrid Battery Voltage Sensor "H" Circuit Low
   P0B65-123	Hybrid Battery Voltage Sensor "I" Circuit Low
   P0B6A-123	Hybrid Battery Voltage Sensor "J" Circuit Low
   P0B6F-123	Hybrid Battery Voltage Sensor "K" Circuit Low
   P0B74-123	Hybrid Battery Voltage Sensor "L" Circuit Low
   P0B79-123	Hybrid Battery Voltage Sensor "M" Circuit Low
   P0B7E-123	Hybrid Battery Voltage Sensor "N" Circuit Low
   P0B83-123	Hybrid Battery Voltage Sensor "O" Circuit Low
   P308A-123	Hybrid Battery Voltage Sensor All Circuits Low

   HINT: 

   P0AFC-129 may be output due to a malfunction which causes the DTCs in the table above to be output. In this case, first troubleshoot the output DTCs in the table above. Then, perform a reproduction test to check that no DTCs are output.

5. Turn the ignition switch off.

B → See step   5 

A → See step   3