DTC P0A1A-151: Generator Control Module; DTC P0A1C-709: Drive Motor "B" Control Module: Procedure

WARNING: This page is about a different variant/trim than selected.

CHECK FREEZE FRAME DATA

Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.

Read the freeze frame data of DTC P0A1A-151 and P0A1C-709.

Result

Result	Proceed to
+B is below 11V.	A
+B is 11V or higher.	B

Turn the ignition switch off.

B → See step 3

A: Go to next step

CHECK AUXILIARY BATTERY
1. Check the auxiliary battery voltage. Refer to ON-VEHICLE INSPECTION .
NEXT → END
REPLACE INVERTER WITH CONVERTER ASSEMBLY. Refer to REMOVAL