DTC P0A0F-204: Engine Failed to Start; DTC P0A0F-205: Engine Failed to Start; DTC P0A0F-206: Engine Failed to Start; DTC P0A0F-524: Engine Failed to Start; DTC P0A0F-525: Engine Failed to Start: Procedure

WARNING: This page is about a different variant/trim than selected.

CHECK DTC OUTPUT (ENGINE CONTROL SYSTEM)

Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

Check if DTCs are output.

Result

Result	Proceed to
Engine control system DTCs are not output.	A
Engine control system DTCs are output.	B

HINT:

If P0A0F-204, 205, 206, 524, or 525 is output even though the ECM has not detected a malfunction, there is a malfunction in the hybrid vehicle control ECU.

Turn the ignition switch off.

B → See step 2

A → See step 3

GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART
REPLACE HYBRID VEHICLE CONTROL ECU. Refer to REMOVAL