On-Vehicle Inspection

1. Turn the ignition switch on (IG).
2. When the driver seat belt is not fastened, check that the driver seat belt warning light on the combination meter blinks.
3. When the driver seat belt is fastened, check that the driver seat belt warning light on the combination meter is off.

1. Turn the ignition switch on (IG).
2. When the front passenger seat belt is not fastened with the passenger seat occupied, check that the front passenger seat belt warning light on the clock display blinks.
3. When the front passenger seat belt is fastened with the passenger seat occupied, check that the front passenger seat belt warning light on the navigation receiver^*1 or hazard warning switch^*2 is off.

   HINT: 

   • ^*1 : w/ Navigation System
   • ^*2 : w/o Navigation System

HINT: 

• If the buzzer does not sound, the buzzer cancel setting may be set to ON.
• Only Techstream can change the buzzer cancel setting to off. Refer to CUSTOMIZE PARAMETERS
• The buzzer sounds for 6 seconds if the front seat belts are not fastened even while the vehicle is stationary.

1. Start the engine.
2. When the vehicle is driven at approximately 20 km/h (12.5 mph) or more with the driver or front passenger seat belt not fastened, check that the buzzer in the combination meter assembly sounds at intervals of 1.2 seconds for 30 seconds.
3. With the belt remaining unfastened, check that the buzzer changes and sounds at intervals of 0.4 seconds for 90 seconds.
4. Check that the buzzer stops 2 minutes after the buzzer starts sounding.
5. After the buzzer has stopped, turn the ignition switch off and then start the engine again. Drive the vehicle at approximately 20 km/h (12.5 mph) or more with the driver or front passenger seat belt not fastened, and then check that the buzzer sounds again.
6. After the buzzer has stopped, fasten the driver and front passenger seat belts. Drive the vehicle at approximately 20 km/h (12.5 mph) or more and unfasten the driver or front passenger seat belt, and then check that the buzzer sounds again.
7. After the buzzer has stopped, move the shift lever to the R position, and then move it to the D position. Drive the vehicle at approximately 20 km/h (12.5 mph) or more, and then check that the buzzer sounds again.