Driver Side Seat Belt Warning Light does not Operate: Procedure
- CHECK FOR DTCs
- Check for DTCs.
Result
Result Proceed to Output DTC (CAN communication) A Output DTC (Airbag system) B No output DTC C
A → See step 3
B → See step 4
C: Go to next step
- Check for DTCs.
- PERFORM ACTIVE TEST USING TECHSTREAM
- Operate Techstream according to the steps on the display and select "ACTIVE TEST".
Combination Meter
Tester Display Test Part Control Range Diagnostic Note Driver Side Seat Belt Driver side seat belt warning light Driver side seat belt warning light is OFF / ON Confirm that the vehicle is stopped, engine idling OK
Switch condition (ON/OFF) can be switched by "ACTIVE TEST".
NG → See step 5
OK → END
- Operate Techstream according to the steps on the display and select "ACTIVE TEST".
- GO TO CAN COMMUNICATION SYSTEM. Refer to HOW TO PROCEED WITH TROUBLESHOOTING
- GO TO AIRBAG SYSTEM. Refer to DIAGNOSTIC TROUBLE CODE CHART
- REPLACE COMBINATION METER ASSEMBLY. Refer to REMOVAL