DTC P0AC0-123: Hybrid Battery Pack Current Sensor Circuit Range / Performance: Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK DTC OUTPUT (DTC P0AFC-123 IS OUTPUT) See step 1
B → See step 6
A: Go to next step
- REPLACE HYBRID VEHICLE RELAY ASSEMBLY
- Replace the hybrid vehicle relay assembly. Refer to REMOVAL .
NEXT: Go to next step
- CLEAR DTC
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
- Clear the DTCs and freeze frame data. Refer to DTC CHECK / CLEAR .
- Perform a road test to charge and discharge the HV battery assembly.
HINT:
2 trip detection logic is used. After the first road test, turn the ignition switch off and perform a road test again.
NEXT: Go to next step
- RECONFIRM DTC OUTPUT
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
- Read output DTCs. Refer to DTC CHECK / CLEAR
.RESULT
Result Proceed to DTCs P0AC0-123 is not output. A DTCs P0AC0-123 is output. B
B → See step 5
A → END (HYBRID VEHICLE RELAY ASSEMBLY IS FAULTY)
- REPLACE BATTERY SMART UNIT. Refer to REMOVAL
- GO TO DTC P0AFC-123. Refer to DTC P0AFC-123: Hybrid Battery Pack Sensor Module