Meter Illumination is Always Dark: Procedure

1. Check if CAN communication DTC is output. Refer to DIAGNOSIS SYSTEM .

   Result

   Result	Proceed to
   CAN communication DTC is not output.	A
   CAN communication DTC is output.	B

B → See step   5 

A: Go to next step 

1. Check if DTC B1244 is output. Refer to DTC CHECK / CLEAR .

   Result

   Result	Proceed to
   B1244 is not output.	A
   B1244 is output.	B

B → See step   6 

A: Go to next step 

1. Connect Techstream to the DLC3.
2. Ignition switch on (IG).
3. Turn the tester on.
4. Turn the light control rheostat to the TAIL/HEAD position.
5. Enter the following menus: Body Electrical / Main Body / Data List.
6. Check the meter illumination.
   MAIN BODY:
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Illumination Rate Info	Illumination rate information / 0 ms. to 99.99 ms.	0.8 to 22.0 ms (Value is output according to outside illuminance)	-

   OK

   Normal condition listed above is displayed.

   HINT: 

   Meter illumination is adjusted by automatic light control system and controlled according to the outside light. The automatic light control sensor sensitiveness can be customized. Therefore, when the Data List value is normal, confirm the sensitivity setting in the customization table of the automatic light control system.

NG → See step   4 

OK → See step   7 

1. Replace the combination meter assembly with a new or a normal one. Refer to REMOVAL - Step 3 .

   OK

   The operation of the combination meter assembly returns to normal.

NG → REPLACE MAIN BODY ECU 

OK → END