Door LOCK Position Circuit: Procedure

1. Connect Techstream to the DLC3.
2. Turn the ignition switch on (IG).
3. Turn Techstream on.
4. Select the following menu items: Body Electrical / Main Body / Active Test.
   MAIN BODY:
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   D-Door Lock Pos SW	Driver side door lock position switch signal / ON or OFF	ON: Driver side door unlocked OFF: Driver side door locked	-
   P-Door Lock Pos SW	Front passenger side door lock position switch signal / ON or OFF	ON: Front passenger side door unlocked OFF: Front passenger side locked	-
   RL-Door Lock Pos SW	Rear door lock position switch LH signal / ON or OFF*1	ON: Rear door LH unlocked OFF: Rear door LH locked	-
   	Rear door lock position switch LH or RH signal / ON or OFF*2	ON: Rear door LH or RH unlocked OFF: Rear door LH and RH locked	-
   RR-Door Lock Pos SW	Rear door lock position switch RH signal / ON or OFF*1	ON: Rear door RH unlocked OFF: Rear door RH locked	-
   	Rear door lock position switch LH or RH signal / ON or OFF*2	ON: Rear door LH or RH unlocked OFF: Rear door LH and RH locked	-

   HINT: 

   • *1: w/ Smart Key System, w/ Power Back Door, w/ Glass Hatch Opener
   • *2: w/o Smart Key System, w/o Power Back Door, w/o Glass Hatch Opener

   OK

   Normal conditions listed above are displayed.

   HINT: 

   If the normal condition listed above are not displayed, perform the trouble shooting of the power door lock control system.

NG → GO TO POWER DOOR LOCK CONTROL SYSTEM 

OK → See step   2