Television Display Power Source Circuit: Procedure

1. Disconnect the television display assembly connector.
   Fig 1: Checking Harness And Connector (Television Display Assembly - Battery, Body Ground)

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the resistance according to the value(s) in the table below.

   Standard resistance

   Tester Connection	Condition	Specified Condition
   Q13-12 (GND6) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard voltage

   Tester Connection	Condition	Specified Condition
   Q13-16 (+B2) - Body ground	Always	11 to 14 V
   Q13-15 (ACC4) - Body ground	Ignition switch on (ACC)	11 to 14 V

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   2