TC and CG Terminal Circuit: Procedure

1. Disconnect the D72 ECU connector.
   Fig 1: Checking Harness And Connector (DLC3 - Hybrid Vehicle Control ECU And Body Ground)

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the resistance according to the value(s) in the table below.
   Fig 2: Measuring Resistance Of DLC3

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Standard resistance

   Tester Connection	Condition	Specified Condition
   D47-13 (TC) - D72-11 (TC)	Always	Below 1 Ω
   D47-13 (TC) or D72-11 (TC) - Body ground	Always	10 kΩ or higher
   D47-4 (CG) - Body ground	Always	Below 1 Ω

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR OR EACH ECU 

OK: Go to next step 

1. Connect the D72 ECU connector.
   Fig 3: Measuring Voltage Of DLC3

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the voltage according to the value(s) in the table below.

   Standard voltage

   Tester Connection	Condition	Specified Condition
   D47-13 (TC) - D47-4 (CG)	Ignition switch ON	11 to 14 V

NG → REPLACE HYBRID VEHICLE CONTROL ECU 

OK → See step   3