Driver Side Seat Belt Warning Light does not Operate: Procedure

1. Check for DTCs.

   Result

   Result	Proceed to
   Output DTC (CAN communication [w/ Smart Key System])	A
   Output DTC (CAN communication [w/o Smart Key System])	B
   Output DTC (Airbag system)	C
   No output DTC	D

A → See step   3 

B → See step   6 

C → See step   4 

D: Go to next step 

1. Operate Techstream according to the steps on the display and select "ACTIVE TEST".

   Combination Meter

   Tester Display	Test Part	Control Range	Diagnostic Note
   Driver Side Seat Belt	Driver side seat belt warning light	Driver side seat belt warning light is OFF / ON	Confirm that the vehicle is stopped, engine idling

   OK

   Switch condition (ON/OFF) can be switched by "ACTIVE TEST".

NG → See step   5 

OK → PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE