DTC P0AC0-817: Hybrid Battery Pack Current Sensor Circuit Range / Performance: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
4. Check if DTCs are output.

   Result

   Result	Proceed to
   P0AC0-817 only is output.	A
   P0AFC-123 is output.	B

5. Turn the ignition switch off.

B → See step   7 

A: Go to next step 

1. Replace the hybrid battery junction block assembly. Refer to REMOVAL .

NEXT: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
4. Read and record the DTCs and freeze frame data.
5. Clear DTCs and freeze frame data.
6. Turn the ignition switch off.

NEXT: Go to next step 

1. Perform a road test.

NEXT: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
4. Check if DTCs are output.

   Result

   Result	Proceed to
   P0AC0-817 is not output.	A
   P0AC0-817 is output again.	B

5. Turn the ignition switch off.

B → See step   6 

A → COMPLETED